Body diodes may be utilized as freewheeling diodes for inductive loads in configurations such as H-bridge or half bridge.
2.
Another three pontoons, built during the west-half bridge replacement in the early 1980s, will be retrofitted in Seattle.
3.
A single resistor may be used, or a pair ( half bridge ), or four resistors connected in a Wheatstone bridge configuration.
4.
The full-bridge inverter is similar to the half bridge-inverter, but it has an additional leg to connect the neutral point to the load.
5.
When the centre of a half bridge goes low the capacitor is charged via a diode, and this charge is used to later drive the gate of the high side FET gate a few volts above the source or emitter pin's voltage so as to switch it on.
मोबाइल